Re: Info: (org)Customizing tables in ODT export

[tsd@tsdye.com (Thomas S. Dye)]

Hi Achim,

I found my way to the top of the 'make update' output.  It looks like
makeinfo thinks all is well (assuming its complaints would be visible
here): 

makeinfo --no-split org.texi -o org
makeinfo --html --number-sections --no-split -o org.html org.texi

Achim Gratz <Stromeko@nexgo.de> writes:

>> These are the only failures I could see in the log available to me:
>>
>> Output written on orgguide.pdf (47 pages, 346216 bytes).
>> Transcript written on orgguide.log.
>> tar: Failed to set default locale
>> tar: Failed to set default locale
>
> So what _is_ your locale?  This is an indication that either locale data
> is completely missing from the system or that the system libraries
> (glibc etc.) are different then what the exectutables run are linked against.

poto:org-mode dk$ locale
LANG="en_US.UTF-8"
LC_COLLATE="en_US.UTF-8"
LC_CTYPE="en_US.UTF-8"
LC_MESSAGES="en_US.UTF-8"
LC_MONETARY="en_US.UTF-8"
LC_NUMERIC="en_US.UTF-8"
LC_TIME="en_US.UTF-8"
LC_ALL=

I don't know how to check system libraries, etc.

>
>> I have this warning, which doesn't seem pertinent to the documentation:
>
> I wouldn't make that assumption, especially where makeinfo is involved.
> can you set LC_ALL=C or equivalently LC_ALL=POSIX and try again?
>

Not quite sure how to set locale, or whether it is a good idea to make a
permanent change.  I tried this in my bash shell, but with the same
result--the documentation gets built, but that section of the manual is
truncated when I view it with info:

poto:org-mode dk$ LC_ALL=C make

Thanks for taking a look at this.

All the best,
Tom

-- 
Thomas S. Dye
http://www.tsdye.com