Re: org-capture-template: table lines including newline of sorts

[Charles Millar <millarc@verizon.net>]

On 3/16/21 3:34 AM, Uwe Brauer wrote:
> 
>     > On 3/15/21 5:00 PM, Uwe Brauer wrote:
>     > My bad; I did not pay attention to a four line comment, so here it is
>     > again, with the comment and final line for the template, etc.
> 
>     > (setq org-capture-template '(
> 
>     > . . . some capture templates
> 
>     >                 ("s" "timeslip" table-line
>     >      	     (file "/mnt/Data/ActiveFiles/timeslips.org")
>     >        ;;    	    (file "d:/ActiveFiles/timeslips.org")
>     >     	          "\| %(org-read-date)\| %^{FileName} %i\|
>     >     	          %^{Narrative} %i\| %^{Time} %i\| %^{Expense} %i"
> 
>     > ;; Note that there is no escape and pipe after the final content input
>     >    expansion
>     > ;; if there were a \| then an empty column is added
>     > ;; (org-read-date) added 2013-07-12; see Sacha Chua's use of same as in
>     > ;; the ledger templates below.
>     >                  :empty-lines 1)
> 
>     > , , , some more capture templates
> 
>     > ))
> 
> 
> I still obtain
> 
> | Bad template
> 
> 
> Even copying your code without any modifications! I am running org
> 9.3.7
> 
I'm running org 9.4.4 and emacs 28.0.50, (both from source) on Debian 
testing. According to my notes in my init file I created the template in 
early July 2011, modified it slightly two years later. I do not recall 
any problems with it.

Just to  make sure that there is no problem with the timeslips template, 
at least on my system, I commented out all of the capture templates 
before and after the timeslips template and reloaded my init file. I ran 
org-capture (bound to C-cm). The timeslips came up in the dispatcher and 
it ran OK.

I notice that I was off by a key and typed periods and not semicolons in 
the two lines "some capture templates," and, "some more capture templates."

Charlie Millar