Re: Table latex exporting ignores #+ATTR_LATEX:

[Robert Klein <roklein@roklein.de>]

Hi,

On Sun, 25 Mar 2018 19:23:53 +0300
Peter Mukhachev <mukhachev@phystech.edu> wrote:

> $ cat table-source.org
> #+ATTR_LATEX: :align lp{2cm}l
> | Name   | Text | Rationale      |
> | height | 18 m | ATC requriment |
> 
> # Here I export with M-x org-table-export RET org-table-export-
> result.tex RET orgtbl-to-latex RET
> 
> It gives the following (note the alignment string is "lll")
> $ cat org-table-export-result.tex
> \begin{tabular}{lll}
> Name & Text & Rationale\\
> height & 18 m & ATC requriment\\
> \end{tabular}
> 
> However, when I dispatch it via M-x org-latex-export-to-latex, the
> output is the following (alignment stirg is the same as in org file)
> $ tail -n 6 table_source.tex
> \begin{tabular}{lp{2cm}l}
> Name & Text & Rationale\\
> height & 18 m & ATC requriment\\
> \end{tabular}
> \end{center}
> \end{document}%
> 
> 

Can you use body-only export?  (That is, is your table the only content
of your document?)

In elisp (org-latex-export-to-latex nil nil nil t), or interactively
C-c C-e C-b <ENTER>.



Best regards
Robert



> 
> On Sun, 2018-03-25 at 12:55 +0100, Eric S Fraga wrote:
> > On Tuesday, 20 Mar 2018 at 15:43, Peter Mukhachev wrote:  
> > > (org-table-export) can probably do the thing I want. However,
> > > dispatching it with latex backend ends up with #+ATTR_LATEX: line
> > > ignored and exports bare table only in its tabular environment.
> > > However, I would like to be able to control the alignment either
> > > at my
> > > .org file with #+ATTR_LATEX (preferred) or at my top-level .tex
> > > file
> > > using tabular environment.  
> > 
> > Maybe show us a minimal example that does not work?  Ideally, you
> > should
> > have something along the lines of
> > 
> > #+attr_latex: ...  
> > > a | table |  
> > 
> >   
>