Re: Re: Exporting after executing code

From: "Eric Schulte" <schulte.eric@gmail.com>
To: andrea Crotti <andrea.crotti.0@gmail.com>
Cc: emacs-orgmode@gnu.org
Subject: Re: Re: Exporting after executing code
Date: Sat, 12 Sep 2009 12:20:20 -0600	[thread overview]
Message-ID: <m2skeshvob.fsf@gmail.com> (raw)
In-Reply-To: <loom.20090912T193643-812@post.gmane.org> (andrea Crotti's message of "Sat, 12 Sep 2009 17:38:35 +0000 (UTC)")

andrea Crotti <andrea.crotti.0@gmail.com> writes:

> Carsten Dominik <carsten.dominik <at> gmail.com> writes:
>
>> 
>> or, for a lighter solution
>> 
>> http://repo.or.cz/w/org-mode.git?a=blob_plain;f=contrib/lisp/org-eval.el;hb=HEAD
>> 
>> or
>> 
>> http://orgmode.org/worg/org-contrib/org-eval-light.php
>> 
>> But org-babel may really be the way to go.
>> 
>> - Carsten
>>
>
> org-babel is really nice I think, there's only one thing I don't understand yet.
> If I want in the same file to have the source code and the output of the 
> source code how should I do??
>
> Once I enable org-babel it executes everything before exporting??
> No finer settings possible?
>
Hi,

There are four export setting using Org-babel.

- none :: neither the code or the results are exported and the block is
          not run
- code :: the fortified code is exported and the block is not run
- results :: the block is run, and the results are exported
- both :: the block is run and both the code and results are exported

These setting are controlled via the :exports header argument, so for
example in the following code block only the code would be included on
export.

#+begin_src ditaa :file test.png :exports code
   +----------------------+
   |                      |
   |                      |
   |          +-----------+
   |          |           |
   |          |           |
   |          |           |
   |          +-----------+
   |                      |
   +----------------------+
#+end_src

If you grab the latest Org-babel code from
http://github.com/eschulte/org-babel/tree/master then you can set the
exports header argument for an entire subtree by setting the subtree's
"exports" property, for example

** show all
   :PROPERTIES:
   :exports:  both
   :END:

Best -- Eric

>
>
>
> _______________________________________________
> Emacs-orgmode mailing list
> Remember: use `Reply All' to send replies to the list.
> Emacs-orgmode@gnu.org
> http://lists.gnu.org/mailman/listinfo/emacs-orgmode